Save current parts on paths

Hi all,

I was wondering if there is a way to save the amount of products and their positions on a path, so I can start from that point in time. It takes a lot of time for newly created parts to reach the sensors on paths. I’m aware that “Warm Up Time” is an option, but it takes a lot of time to reach the wanted starting time since a lot of tasks have to be performed first.

Kind regards,


Also maybe you should check warm up feeder too.

Run the simulation, and when the needed amount of parts are on the conveyor, stop the simulation. Next, select the component of the path, and then copy and paste it. Finally, reset the simulation. What happens to the parts on the copy?

You could also do something similar to what is shown in this lesson.