Lefa
October 17, 2023, 10:31am
2
Hi KSS,
You are most likely looking for assemblies, here is an example layout but before even opening it up, I would recommend you to hit the Academy first and then check the layout.
asm_example.vcmx (1.5 MB)
This post also explains something about the assemblies:
Hey Oskar,
There’s a couple of ways of doing assemblies so let’s check one of them. First you should begin by defining an assembly in your product editor tab in Process Modelling. This can be seen in figure 1.
[image]
Figure 1
Click the pen next to “Assembly #1”. The pen appears when you hover your cursor on top of the assembly. This will open the assembly editor. The assembly editor, seen in figure 2 should then be configured with proper steps, products and visualization. Please note that …
If the simulation gets “stuck” please detach and the reattach the build node
br,