Introduction to layout configuration - Stop anna on table


I followed the introduction to layout configuration. I get Anna to pick up the piece from the conveyor and put in onto the first assemble table.

During this I get 2 times the message: “Destination might be inside an obstacle or disconnected area.”

Someone that got stuck on the same issue? I would try to share my program but I don’t know if this is possible here.

More information about obstacles and pathways you can find in the Resources Manual

Static obstacle on page 12:

  1. obstacles and 4. pathway in this video:

Hi anhu,

I managed to make a more simple layout working. But from the moment I try the shelf it isn’t working anymore. Do you know how to connect a shelf to a human transport?


Could you share your layout or do you get any error messages in output panel?