How to use rotary table as a buffer

General Questions
1

Hi,

I am able to flow a part through a rotary table. However, when i try to put a “from conveyor process” after the rotary table, the parts will not flow anymore. Please advise how can the rotary table be utilized.

The objective is to flow the parts to a rotary table and later use a human to pick it up to transfer it to another process. Therefore, allowing the rotary table to act as an buffer.

image
image579×703 54.7 KB

image
image874×678 56 KB

2

Hi @Poh123

You can connect a short conveyor to the rotary table and then connect the from conveyor process to that conveyor. Then it should start working.

I will investigate why this trick is needed, and once I do, I will push the update to eCatalog.

3

Thanks @Este that works well.