haroon

Forum Replies Created

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • in reply to: Accessing Raycast sensor properties #6979
    Avatar
    haroon
    Participant

    @dubs3pp & @zesty ….. Thank you both
    but I am actually using a function to have the raycast sensor rather than using it from the tool
    So I need to access things like the UpdateScene, SampleTime etc
    I am still confused in it to access those parameters
    The code is the following

     

    in reply to: Video recording does not work properly #6948
    Avatar
    haroon
    Participant

    OK thanks for the help 🙂
    I got the proper settings for external screen grabber.
    Step through I misunderstood for something else.
    I will look into the logfile myself now.

    The basic problem I am facing is the slow simulation speed due to the several raycast sensors used.
    I solved the video making process by using an external grabber.

    in reply to: Check precise timing #6941
    Avatar
    haroon
    Participant

    @eme
    thanks but this gives the time of each loop of i in xrange(10000): right ?
    and why   a = i/(i+10) ??

    in reply to: Check precise timing #6940
    Avatar
    haroon
    Participant

    @dubs3pp
    No, its been a minute and the real time is still in 0:00:00

    @eme
    thanks but this gives the time of each loop of i in xrange(10000): right ?
    and why   a = i/(i+10) ??

    in reply to: Video recording does not work properly #6938
    Avatar
    haroon
    Participant

    In Simulink the time T is faster than the SimTime of the Simulation
    The Simulation simtime is something like in 0.0001234
    and when the connection to Simulink stops, then the timer on top continues faster by completing 1st second and counting faster furtherly

    Step through mode ???

    Yes its under OnRun() event

    The problem is the whole simulation takes like 20 minutes
    and if I use the external screengrabber
    It becomes bigger than 4gb in like 3 minutes
    So it is also not practical

    The simulation is too slow probably because of the several ray cast sensors used

    in reply to: Video recording does not work properly #6925
    Avatar
    haroon
    Participant

    Does the screen go black when you run the simulation without recording video?
    NO

    Did you try recording with a simulation mode of Real Time?
    YES same result, black screen

    Are you doing any camera movements during simulation?
    YES and NO, no effect in both cases

     

     

Viewing 6 posts - 1 through 6 (of 6 total)