Re: WorksProcess & NeedCustomPattern

Forum Forums Visual Components 4.1 General Product Questions Re: WorksProcess & NeedCustomPattern

Tagged: 

This topic contains 1 reply, has 2 voices, and was last updated by Avatar jouha 2 months, 2 weeks ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #18541
    Solrac
    Solrac
    Participant

    So I want to create a three different sized rows of parts leaning at a 20° angle as if they were leaning of a rack. Therefore I wanted to use NeedCustomPattern.

    The issue in the syntax in the WorksTaskControl notes is ProdID,Tx,Ty,Tz,Rz, Ry, Rx the rotational coordinates dont seem to affect the part at all. This is also only for the NeedCustomPattern not CreateCustomPattern where it works just fine.

    Is there any setting that I have missed or could this be some kind of bug? Thanks in advance.

    0
    #18545
    Avatar
    jouha
    Moderator

    Hi @calbrecht

    In the needing process uncheck “KeepProdOrientation” under the “Advanced” tab.

    0
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.