Routing rule problems

Forum Forums Visual Components 4.0 Layout Configuration Routing rule problems

Be sure to read the Forum Rules and Guidelines before start using the Forum.

This topic contains 2 replies, has 3 voices, and was last updated by ccamilo ccamilo 10 months, 1 week ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
  • #3482



    I am suffering from the configuration of routing rule.At first, I set it up and everything went very well.

    But I don’t know when an error suddenly happened, showing a duplicated value.

    what on earth happened? I did nothing.

    By the way, what is the ‘Default’ used for?

    Best wishes.




    “Default” is used when the value of the variable, in your case “ToBeChecked”, has a value that is not defined in the corresponding table rule.

    In your case you could for example remove all entrys for the value “False” and then select “Straight_out” in “Default”. The behaviour should be the same!


    In the next release, “Default” will also be used when the variable itself does not exist.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.